Yes, that is trailing behind. It appears to be following at a distance. **

To plant trailing geraniums correctly, start by choosing a location that receives full sun to partial shade. Make sure the soil is well-draining and amend it with compost if needed. Dig a hole slightly larger than the root ball of the geranium and place the plant in the hole, making sure it sits at the same level as it was in the container. Water the plant thoroughly after planting and continue to water regularly, allowing the soil to dry out slightly between waterings. Fertilize the geraniums every 4-6 weeks with a balanced fertilizer to promote healthy growth and blooming. **

No, the number 0180 6 672255 is not a legitimate Microsoft support number. Microsoft typically uses toll-free numbers for customer support, and this number does not match their official contact information. It is important to be cautious of unsolicited calls or messages claiming to be from Microsoft, as they could be scams attempting to gain access to personal information or financial details. It is recommended to verify the authenticity of any communication from Microsoft through their official website or customer support channels. **

To call an 0180 number in Germany, you can simply dial the number as you would with any other German phone number. However, keep in mind that 0180 numbers are usually charged at a higher rate than regular landline numbers. It's important to check with your phone service provider for the specific rates and any potential additional charges for calling 0180 numbers. If you are calling from a mobile phone, the charges may vary depending on your mobile plan. **

The first layer in Cura V45 may appear thin after exporting because the initial layer height setting is set to a lower value. This setting determines the thickness of the first layer of the print. If the initial layer height is set too low, the first layer may appear thin. It is important to check and adjust the initial layer height setting to ensure the first layer is of the desired thickness for proper adhesion and print quality. **

The dimmer used can vary depending on the type of lighting fixture being controlled. Leading edge dimmers are typically used with incandescent and halogen bulbs, while trailing edge dimmers are more commonly used with LED and CFL bulbs. It is important to match the dimmer type with the appropriate lighting technology to ensure optimal performance and compatibility. **

Trailing-edge dimmers are typically used for LED and electronic low-voltage lighting, as they provide a smoother dimming experience and help prevent flickering. On the other hand, leading-edge dimmers are more commonly used for incandescent and halogen lighting. The choice between leading-edge and trailing-edge dimmers depends on the type of lighting being used and the desired dimming performance. **

The waiting loop for an 0180 number may or may not be free of charge, depending on the specific company or service provider. Some companies may offer a free waiting loop for their 0180 number, while others may charge a fee for the time spent waiting on the line. It is important to check with the company or service provider to understand their specific policies regarding the waiting loop for their 0180 number. **