Yes, that is trailing behind. It appears to be following at a distance. **

To plant trailing geraniums correctly, start by choosing a location that receives full sun to partial shade. Make sure the soil is well-draining and amend it with compost if needed. Dig a hole slightly larger than the root ball of the geranium and place the plant in the hole, making sure it sits at the same level as it was in the container. Water the plant thoroughly after planting and continue to water regularly, allowing the soil to dry out slightly between waterings. Fertilize the geraniums every 4-6 weeks with a balanced fertilizer to promote healthy growth and blooming. **

The first layer in Cura V45 may appear thin after exporting because the initial layer height setting is set to a lower value. This setting determines the thickness of the first layer of the print. If the initial layer height is set too low, the first layer may appear thin. It is important to check and adjust the initial layer height setting to ensure the first layer is of the desired thickness for proper adhesion and print quality. **

The dimmer used can vary depending on the type of lighting fixture being controlled. Leading edge dimmers are typically used with incandescent and halogen bulbs, while trailing edge dimmers are more commonly used with LED and CFL bulbs. It is important to match the dimmer type with the appropriate lighting technology to ensure optimal performance and compatibility. **

Trailing-edge dimmers are typically used for LED and electronic low-voltage lighting, as they provide a smoother dimming experience and help prevent flickering. On the other hand, leading-edge dimmers are more commonly used for incandescent and halogen lighting. The choice between leading-edge and trailing-edge dimmers depends on the type of lighting being used and the desired dimming performance. **

Image trailing effects, also known as ghosting, on monitors can be caused by a few different factors. One common reason is slow response time of the monitor, which can result in images not refreshing quickly enough and leaving a trail behind moving objects. Another reason can be the use of outdated or low-quality cables, which can result in signal interference and ghosting. Additionally, if the monitor's refresh rate is not properly synchronized with the graphics card, it can lead to ghosting effects. Finally, image trailing can also be caused by a phenomenon called overdrive, where the pixels on the screen cannot transition between colors fast enough, resulting in ghosting. **

Omitting trailing zeros in decimal fractions is not the same as expanding or reducing. When trailing zeros are omitted, the value of the decimal fraction remains the same, as the zeros do not affect the actual value of the number. Expanding or reducing a decimal fraction involves changing the value of the number by adding or removing digits before or after the decimal point. **

To plant cuttings of Devil's Ivy, start by taking a 4-6 inch cutting from a healthy, mature plant. Remove the lower leaves from the cutting and place it in a jar of water, making sure that at least one node (where the leaf was attached) is submerged. Change the water every few days to prevent rot and place the jar in a warm, bright location but out of direct sunlight. Once roots have developed, transfer the cutting to a well-draining potting mix and keep the soil consistently moist. Devil's Ivy prefers indirect light and moderate humidity, so be sure to provide these conditions for optimal growth. **